Color Cartridges:

1. Filler holes are located under red top. Remove top using think blade, being careful not to damage sensors on back of cartridge. (see Removing Head From a Cartridge Video)
2. Assemble syringe and fill with desired color of ink.
3. Insert needle into hole of color to be refilled and push all the way in.
4. Slowly inject up to 8 ml of ink until until ink just starts to surface.
5. Refit top and seal with adhesive tape.
6. Clean syringe with water and dry before using with another color.

Black Cartridge: (Use Black Pigment Ink Only)

1. Protect work surface with newspaper or paper towels.
2. Remove ink cartridge from printer according to printer manufacturer’s instructions.
3. Using drill tool provided, drill the hole using a clockwise twisting motion. Withdraw drill tool. Holding the print cartridge vertically, insert syringe into vent hole as far as it will go.
4. Fill syringe with 10 mls. of ink.
5. Gently push the plunger in to inject the ink. Continue dispensing ink until the entire syringe is emptied, or until a droplet of ink appears at the fill hole indicating that the cartridge is full.
6. Repeat process with another 10 mls. of black ink.
7. Remove syringe. Blot up any residual ink around air vent with a tissue. Allow a few minutes for the ink to re-wet the print head.
8. Reinstall the cartridge into the printer and perform the print head cleaning procedure, following the instructions outlined in your printer instruction booklet.
9. Wash syringe with warm water before refilling with another color.